Alogic Flux Flexible Single Monitor Arm

Alogic Flux Flexible Single Monitor Arm

The Alogic Flux Flexible Single Monitor Arm is a monitor arm that lifts your screen off your desk and sets it at the height where you work comfortably. It supports screens from 17 to 49 inches weighing between 2 and 20 kg, flat or curved. Even a wide ultrawide stays within reach with this arm.

Adjusting is done with one hand. You rotate the screen 180 degrees left or right, swivel it 90 degrees either way and tilt it 50 degrees forward to 20 degrees backward. Set your screen upright in portrait mode for long documents or code, or turn it towards a colleague for a moment. The reinforced counterweight mechanism then keeps the screen in place, even when it's heavy.

You mount the arm in two ways. With the clamp, you set it up on the edge of your desk in a few minutes. If your desk sits against the wall, you use the grommet mount and pass the base through an existing cable hole. Both work on desktops 12 to 50 mm thick.

The screen hangs from a VESA quick-release plate. You screw that onto your monitor first and then click it into the arm, so you can later remove the screen again in a single motion. The arm fits VESA 75 x 75 mm and 100 x 100 mm. You press your cables into the click-in channels along the arm, so they run out of sight to your desk. The whole thing is built from aluminium and steel with a polished chrome finish.